What are the sports floor construction techniques?

1. Both the coil and the block should be placed on site for more than 24 hours to restore the material memory and the temperature is consistent with the construction site. 2. Use a special edger to cut and clean the burrs of the coil. 3. When the block is laid, the two pieces of material should be in close contact with each other. 4. When the coil is laid, the overlap between the two materials should be overlapped and cut, usually requiring an overlap of 3 cm. Be careful to keep cutting. Seven, the pavement of the floor - paste 1. Select the appropriate glue and squeegee for the prefabricated elastic flat wood look indoor sport flooring. 2. When the coil is laid, fold one end of the coil. First clean the floor and the back of the coil, then scrape the glue on the floor. 3. When the block is laid, please turn the block from the middle to the sides. Also, clean the floor and the back of the floor and glue it. 4. Different adhesives will have different requirements during construction. For details, please refer to the corresponding product manual for construction. Eight, the pavement of the floor - exhaust, rolling 1. After the floor is pasted, first push the floor surface with a cork block to level and squeeze out the air. 2. Then uniformly roll the prefabricated elastic flat PP mat sport flooring with a 50 or 75 kg steel press roll and trim the hem at the joint. 3. The excess glue on the floor surface should be wiped off in time. 4. After 24 hours, perform the groove and weld. Nine, the paving of the floor - slitting 1. Slotting must be done after the glue has fully cured. Use a special slotting device to groove along the seam. For the welding to be firm, the slit should not penetrate the bottom. It is recommended that the groove depth be 2/3 of the thickness of the floor. 2. At the end where the slitter cannot be opened, use a manual slitter to slit at the same depth and width. 3. Remove any dust and debris from the tank before welding. Ten, the pavement of the floor - weld 1. Weld seams can be made using hand torches or automatic welding equipment. 2. The temperature of the torch should be set at approximately 350 degrees. 3. Squeeze the electrode into the open slot at a uniform rate (to ensure that the electrode melts). 4. When the electrode is semi-cooled, use a welding strip screed or a monthly cutter to cut the portion of the electrode above the plane of the floor. 5. When the electrode is completely cooled, divide the remaining protrusion of the electrode using a welding strip screed or a monthly cutter. 11. Cleaning and maintenance of the floor 1. The PVC sports flooring brand series is designed and developed for indoor venues and should not be used in outdoor venues. 2. According to the method recommended by the manufacturer of the sports flooring brand, select the appropriate cleaning agent for regular cleaning and maintenance. 3. High concentrations of solvents such as toluene, banana water and strong acids should be avoided. The alkali solution should be poured onto the detachable futsal sport floor tiles. Avoid using inappropriate tools and sharp scrapers or damage the floor surface. Twelve, sports floor construction tools 1. Floor treatment: surface humidity tester, surface hardness tester, floor grinding machine, high-power industrial vacuum cleaner, wool roller, self-leveling mixer, 30-liter self-leveling mixing drum, self-leveling flat scraper, spiked shoes, self-flow Flat deflate. 2. Floor laying: floor trimmer, cutter, two-meter steel ruler, glue scraper, steel press roll, slotting machine, welding torch, monthly cutter, electrode stripper, combined scriber.

Dislike 0

Tags

hasnainkhatri
07/28/20 12:33:51PM @hasnainkhatri:
Thannk you for sharing these floor construction techniques here with us, mate. I am going to tell my https://subscriptionboxesformen.club/golf-subscription-boxes/ friends about these techniques now, and I am sure they'll appreciate this a lot.
hasnainkhatri
07/28/20 12:07:14PM @hasnainkhatri:
If you need to find out all of the new flooring techniques then I would suggest you to check out this website. It shows the most recent techniques that have been used for it.
bravehassan222
05/12/20 06:55:56PM @bravehassan222:
Pretty good post. I just stumbled upon your blog and wanted to say that I have really enjoyed reading your blog posts. Any way I'll be subscribing to your feed and I hope you post again soon. Big thanks for the useful info. smm panel
sohailkhatri
12/26/19 09:57:38AM @sohailkhatri:
Moreover the lighting system is also sensor base as when I don't use it martial boss, and then it will sleep until and unless I move it again.
afiya ali
11/22/19 05:26:59AM @afiya-ali:
This article gives the light in which we can observe the reality. This is very nice one and gives indepth information. Thanks for this nice article.
https://gmo.blog.polityka.pl/2013/01/31/gmo-box-office-styczen/

afiya ali
11/17/19 06:26:31AM @afiya-ali:
Today, I was just browsing along and came upon your blog. Just wanted to say good blog and this article helped me a lot, due to which I have found exactly I was looking.
http://itf.fys.kuleuven.be/~toine/wwwadres.htm

afiya ali
11/13/19 12:00:50AM @afiya-ali:
Nice to be visiting your blog again, it has been months for me. Well this article that i've been waited for so long. I need this article to complete my assignment in the college, and it has same topic with your article. Thanks, great share.
http://www.otopaczkow.pl/news.php?id=74487&tytul=zbliza-sie-polcon-2012

afiya ali
11/11/19 11:40:57PM @afiya-ali:
Wow, this is fascinating reading. I am glad I found this and got to read it. Great job on this content. I liked it a lot. Thanks for the great and unique info.
http://www.paranormalne.pl/topic/30698-polcon-2012/

afiya ali
11/02/19 02:30:51PM @afiya-ali:
nice bLog! its interesting. thank you for sharing....
https://www.rosenoisettes.com/2016/03/smoothie-bowl-la-fraise-kiwi-et-ananas.html

afiya ali
10/21/19 03:59:15AM @afiya-ali:
Best work you have done, this online website is cool with great facts and looks. I have stopped at this blog after viewing the excellent content. I will be back for more qualitative work.
aloe saponaria

afiya ali
10/19/19 05:40:58PM @afiya-ali:
Best work you have done, this online website is cool with great facts and looks. I have stopped at this blog after viewing the excellent content. I will be back for more qualitative work.
aromatic plants

afiya ali
10/17/19 03:51:56AM @afiya-ali:
Today, I was just browsing along and came upon your blog. Just wanted to say good blog and this article helped me a lot, due to which I have found exactly I was looking.
https://cafequenteesherlock.blogspot.com/2014/12/

saeed.khatri
10/13/19 02:32:51AM @saeedkhatri:
I think this is a really good article. You make this information interesting and engaging. You give readers a lot to think about and I appreciate that kind of writing.
remembrance sunday prayers

saeed.khatri
10/11/19 03:54:22AM @saeedkhatri:
Today, I was just browsing along and came upon your blog. Just wanted to say good blog and this article helped me a lot, due to which I have found exactly I was looking.
remembrance sunday poems

saeed.khatri
10/06/19 03:27:13PM @saeedkhatri:
Today, I was just browsing along and came upon your blog. Just wanted to say good blog and this article helped me a lot, due to which I have found exactly I was looking.
weed for sale near me

xzbbvfvbh
Followers:
stats